Vinotemp WM1500HTD Manual y guía del usuario

wwwwww..wwiinneemmaattee..ccoomm Wine Cooling System Installation, Use & Care Manual WM-1500HTD WM-1500HTD-TE WM-2500HTD WM-2500HTD-TE

- 9 - Fig. 2.6 TOP EXHAUST GASKETS Fig. 2.7 MOUNTING OOLING UNIT

- 10 - Fig. 2.8 MOUNTING FRONT COVER Fig. 2.9 COOLING UNIT MOU

- 11 - Fig. 2.10 COOLING UNIT MOUNTED (TOP EXHAUST) Fig. 2.11 INST

- 12 -Temperature and Humidity 1. The controller Fig. 3.1 TEMPERATUR

- 13 -4) Alarm Signals The alarm codes are described as follows. ME

- 14 -6. Parameter Programming 1) Press and hold the SET + keys unti

- 15 -In case there is excessive frost, the parameters FnC = C-y, idF

- 16 -Care Guide 1. Cleaning Condenser • Clean the condenser regu

- 17 -Troubleshooting This Troubleshooting Chart is not prepared to r

- 18 -high or not cooling and running continually b. Cellar too la

- 1 -Important Safety Information • DO NOT PLUG IN UNTIL 24 HOURS AF

- 19 -low b. Low ambient temperature c. Air probe fault d. Temperatu

- 20 -Wiring Diagram Fig. 6.1 WIRING DIAGRAM

- 21 - Fig. 6.2 WIRING DIAGRAM (ALARM CALL)

- 22 -Customer Support If you need further assistance, please contac

- 23 -Warranty Thank you for choosing a Vinotemp cooling unit. Ple

- 24 -is determined to be faulty and is within the twelve month warran

- 2 -Table of Contents Features & Specifications.…………………….…………….

- 3 -Features and Specifications • WM-1500HTD, HTD-TE and WM-2500HT

- 4 - Fig. 1.2 DIMENSIONS (in) The specifications and dimensions are

- 5 -Installation Instructions NOTES: • Mounting brackets, screws, g

- 6 -ambient-air intake and hot-air exhaust must not be short-circulat

- 7 - Fig. 2.1 CUTOUT AND HOLE DIMENSIONS Fig. 2.2 REAR EXHAUST CUT

- 8 - Fig. 2.3 TOP EXHAUST CUTOUTS Fig. 2.4 MOUNTING SCREW INSERTS